Powerlifting

8 Steps to Great Bench Technique


Written by

Cover Photo by 9for9 Media

Building massive pressing power requires a combination of strength through the pecs, triceps, shoulders, biceps, forearms, lats, rear delts, rhomboids, and traps, as well as technique and confidence. It is important to understand that as with all the lifts, much of the information you have been presented with in the past via articles/videos was written with geared lifters in mind. While these lifters are strong, the techniques and exercises (max width grip, reduced range of motion lifts, accommodating resistance) they use to improve won’t necessarily translate to your success.

Key technical points in the bench are:

1. Grip width will be individual based upon limb length. Set your hands at a width that allows the bar to be right over your wrist and wrist right over your elbow when it is on your chest. Keeping these three things in line is critical to maximizing power.

2. A tight setup is critical to a big press. In your setup, your knees need to be aligned below your hips to ensure that your butt stays down on the bench through the movement. Think about squeezing your shoulder blades together as tight as possible, and make sure your chest is as high as possible.

3. Whether you are using a thumbless or full thumb grip, you need to squeeze the bar as hard as possible. This will send a tightness response through the body.

4. Tuck the elbows as you bring the bar to your chest. Whether you want to think about bending the bar or any other cue, it is key to engage the lats. Thinking about loading your lats, like you are loading a spring.  Elbows do not need to be overly tucked though, think of a 45 degree angle from your torso with them.

5. There are two styles that are widely used in the bench, a more dynamic style (Dan Green style), in which you lower the bar quickly letting it sink into your chest before the press command-which allows for great leg drive but is a more high-risk, high-reward technique. The other is a more strict style (Brandon Lilly style), in which you pause the bar on your chest by touching it as lightly as possible, maintaining as much tightness as possible through the whole body before getting the press command. One isn’t necessarily better than the other, you just need to see what works best for you.

6. Regardless of style you use, leg drive is critical. Your leg drive should drive you down the bench toward your head, but since your shoulder blades are dug into the bench, you won’t move; instead, the high point of your chest will rise. Your feet should be pressed into the ground (heel up or down depending on federation and comfort), and you should think about doing an explosive leg extension action, but instead of you leg extending, you will drive your body toward your head.

7. The bench press is a violent movement. As you loaded the spring with the descent of the bar, now you must violently uncoil it in the press. As your elbows tuck on the way down, they should flare on the way up.

8. Practice a strong lockout by fully locking out every rep, rather than cutting them short as “bodybuilder reps” and hold the final rep of each set at lockout for a 3-5 count before racking it.

You may also like

Pillars of Bench Technique
Powerlifting

Pillars of Bench Technique

Everything you need to improve your bench technique in one convenient place.

Pillars of Bench Technique | Gripping the Bar
Powerlifting

Pillars of Bench Technique | Gripping the Bar

Chad and Marisa cover grip width, hand placement and wrist position in Part 3 of our Pillars of Bench Technique Series.

Pillars of Bench Technique | Leg Drive & Bar Path
Powerlifting

Pillars of Bench Technique | Leg Drive & Bar Path

We conclude our Pillars of Bench Technique series with Part 5, covering how to generate leg drive and how to use this to influence an …

Addressing Weak Points | Lockout in the Bench Press
Powerlifting

Addressing Weak Points | Lockout in the Bench Press

Missing a bench at lockout is always frustrating, stop it from happening.

Pillars of Bench Technique | Breathing and Bar Placement
Powerlifting

Pillars of Bench Technique | Breathing and Bar Placement

We continue our series on Pillars of Bench Technique with Part 4 detailing breathing patterns during the lift and finding the optimal place to touch …

Step by Step Guide to Better Bench Press Technique
Powerlifting

Step by Step Guide to Better Bench Press Technique

Follow these 4 steps to improve your Bench Press technique

Pillars of Bench Technique | Foot Placement & Pressure
Powerlifting

Pillars of Bench Technique | Foot Placement & Pressure

Cover Photo by 9for9 Media We begin a new series with Part 1 in Pillars of Bench Technique. This episode will cover foot placement and pressure …

Bench Variations | How, Why and When To Use Them
Powerlifting

Bench Variations | How, Why and When To Use Them

Which exercises are best to build your bench?

Shopping cart
There are no products in the cart!
Continue shopping